Skip to content
Home » How Do You Measure Your Draw Length For A Recurve Bow

How Do You Measure Your Draw Length For A Recurve Bow

To measure your draw length, stand with your back to a wall stretching your arms out against the wall. Measure the distance from the end of your middle finger to the end of your other middle finger, basically the length of both arms, hands and chest. This measurement, minus 15 then divided by 2, is your draw length.

Does draw length matter with a recurve bow?

When you have a proper draw length, you shoot better and feel more comfortable at full draw. Unlike a compound, recurves and longbows don’t have set draw lengths. However, the bow-tech must still find your draw length because the bow’s length must match your draw length.

Is draw length measured from front of riser?

Draw length is exactly as the term describes, it is the length (in inches) that a bow is drawn. This length is measured from the front of the Berger hole (where the arrow rest mounts to the riser) to the corner or angle of the string.

What is the draw length of a recurve bow?

Most recurves commonly come in lengths of 58, 60, and 62 inches. The old rule was if you had a short draw length, less than 28 inches, you should shoot a 56 or 58-inch bow. For 28 to 29½-inch draw lengths, a 60-inch bow would perform best.

Is arrow length the same as draw length?

The main difference between draw length and arrow length is the way these two are measured. Draw length Is the distance from the deepest grip of the throat to the nock point plus 1.75″ at full draw. On the other hand, arrow length is the distance of the arrow shaft.

What is a good draw weight for a recurve beginner?

Best recurve bows (top 10 chart) – divided by price range. Beginner recurve bows list.

Archer’s Weight Suggested Draw Weight
Small-Frame Female (100-130 lbs.) 25-35 lbs
Medium-Frame Female (130-160 lbs) 25-35 lbs
Small-Frame Male (120-150 lbs) 30-45 lbs
Medium-Frame Male (150-180 lbs) 40-55 lbs

4 more rows

Is draw length same for compound and recurve?

For a compound shot fingers it will be the same or possibly longer with a recurve as most compounds have a lower grip (riser) than most recurves. So Jim If you are using a similar anchor, not moving your hear the alignment and therefore draw length should be the same.

Can you adjust draw length on a recurve bow?

Compound bows come in many lengths and adjust mechanically to fine tune your draw length. All you have to do is find a bow that can be adjusted to your draw length. Recurve bows come in different lengths that are generally specific to defined ranges.

What is the draw length for a 6 foot man?

6’1″ – 29″ draw. Since that is what you asked for! Thanks!

What happens if your draw length is too short?

If the draw length is too short, you will feel “bunched up” or uncomfortable because you are too compressed. In addition, the elbow will have a fairly big bend in it in order for you to get the string to your face. Often, I am asked whether the elbow should be bent or straight.

How long should arrows be for 28 inch draw?

If you’re a 28-inch draw length and want an arrow that ends at the front of the riser, your arrow length would be around 27 inches. However, your arrow length can be longer if you need to weaken the spine of your arrow. For safety reasons, your arrows shouldn’t be cut too short.

How long should your arrow be compared to draw length?

A good rule of thumb is to cut it no shorter than the middle of the riser. At full draw, your arrow end would sit right in the middle of the shelf. The best way to determine how long you want your arrows to be is to nock a full-length, uncut arrow and draw it back.

What size arrows for a 30 inch draw?

How to: Select the perfect arrow

Bow Arrow length
Draw weight lb. 25″ 30″
15-20 700 600
20-25 700 500
25-30 700 500

15 more rows•Jan 7, 2015

What kind of arrows are best for a recurve bow?

Carbon arrows are probably the all around best choice for most recurve bows, whether it be for practice target shooting, competitions and even hunting. Carbon arrows tend to be accurate, durable and are more safe than cheaper alternatives like fiberglass arrows.

What is a good recurve bow for hunting?

Top hunting bows (2013-2020) – legacy rankings

Model Draw Weight Bow length
Martin Saber Recurve Bow See’s best price 30, 40, 45, 50, 55 lbs. 64 in.
Martin Hunter Recurve Bow See’s best price 40, 45 50, 55 lbs. 62 in.
Bear Archery Super Kodiak See’s best price 50, 55, 60 lbs. 60 in.

2 more rows

What is a good draw weight for hunting?

In terms of being able to effectively take a big game animal, a general rule of thumb is 40 lbs for whitetail deer-sized game and 50 lbs for bigger animals like elk. The bigger the critter, the tougher the hide, thicker the bones and the larger the chest cavity.

How far should your arrow be past your rest?

The best safety practice is to make sure your arrows sit at least 1″ beyond your arrow rest when the bow is at full draw. A little bit of extra arrow length gives the arrows an important margin of safety. A little too long is okay.

How long should arrows be for a recurve bow?

What Arrow Length To Get? Once you’ve determined your draw length, simply add 1 to 2 inches to that, and this will be your ideal arrow length. So if your draw length is 28″, you should be using arrows that are between 29 and 30 inches long.

What arrows for 70lb bow?

A 350 grain arrow (the minimum weight recommended for a 70lb compound bow) moving at 320 feet per second (fps) has a kinetic energy of 79.57 ft-lbs and a momentum of .

How far can a 50 lb recurve bow shoot?

How Far Can a Bow Shoot? | Ranges by Draw Weight (With Chart)

Bow Type Draw Weight Effective Range
40 lbs 50 – 60 yards
Crossbow 80 lbs 30 – 40 yards
150 lbs 40 – 50 yards
200 lbs 50 – 60 yards

8 more rows•4 days ago

What poundage do Olympic archers use?

Bow: In Olympic archery, competitors use recurve bows that draw an average of around 48.5 pounds for the men and 33 pounds for the women. The bow may have a mechanical sight, but no optical enhancements.

Which is easier to shoot recurve or longbow?

Longbows are generally more forgiving than recurves, largely because the grip design and straight limbs make torquing the bow more difficult.

Is recurve harder than compound?

More videos on YouTube

Compound bows are easier to draw, aim and shoot. Their cams or wheels roll over during the draw cycle to reduce the bow’s draw weight at full draw. That let-off goes as high as 90%, meaning archers only hold 7 pounds at full draw on a bow with a 70-pound peak draw weight.

How far can a 25 lb bow shoot?

Contrary to what most people think, a 30 or even a 25 lbs. draw weight is more than enough for recreational target practice. If you have the aim for it and your form is on point, you can successfully hit a target from 60 or even 70 yards away with this kind of draw weight.

What does 75 let-off mean on a bow?

Let-Off. A compound bow uses cables and cams to store energy and reduce the holding weight at full draw. This reduction in holding weight at full draw is called “let-off,” and is calculated as a percentage of the overall draw weight. For example, a 40-pound bow with a 75 percent let-off would be ten pounds at full draw

Can you adjust draw length without a press?

Adjustable cams allow the archer to adjust his or her draw length with the use of an hexagonal wrench without, in most cases, pressing the compound bow. Adjustable compound bow cams allow archers to adjust anywhere from 3 inches up to 13 inches depending on the compound bow.

What is the correct brace height on a recurve bow?

These guidelines work for most recurve bows, but always follow the manufacturer’s recommended brace-height range. 62- and 64-inch bows have 7½- to 8½- inch brace heights. 66- and 68-inch bows have 8- to 9-inch brace heights. 70- and 72-inch bows have 8¾- to 9½-inch brace heights.

What draw weight should I get for a recurve bow?

Choose a recurve bow which has a draw weight of 40 pounds minimum. Now, you can hunt perfectly well for smaller game like turkey and rabbit with a 35 or even 30 lbs. bow, but for anything larger than that (deer, elk) you’ll need 40 lbs. or more. So while you might not be able to handle more than 30 lbs.

What is most common draw length on a bow?

Draw length describes the distance between the bowstring and the grip at full draw. Bows come in different draw lengths, the most common being within the 26 to 29 inch range.

What is a common bow shooting error?

Rushing to place your fingers on the string is one of the most common archery mistakes. Taking a second look at your finger placement can pay big dividends for your shot. Hooking the bowstring with too much finger tension – or in the wrong place on the fingers – can cause many issues.

How much does twisting cables affect draw length?

If you take twist out, it makes the string longer. Doing this to the cables, had a totally opposite effect. If you add twist to the cable/cables, it shortens the cables and this will do 2 things – lengthen the draw length AND increase the draw weight.

Can you overdraw a recurve bow?

Usually at a rate close to 2lbs per inch. At some point the rate will noticeably increase. This is “Stacking” which Hank mentioned. If you draw beyond this point where the bow begins to stack, you are likely overdrawing the bow.

Does longer draw length affect arrow speed?

The longer your draw length, the longer your bow’s powerstroke will be – and the faster your bow will shoot. As a general rule, 1″ of draw length is worth about 10 fps of arrow velocity.

What happens if your arrows are too long?

It can’t hurt if it’s too long if it’s shoots well for you. Too long and you have to have more spine which adds arrow weight, more fletching, and heavier tips for proper FOC (arrow balance).

What size arrows for a 60lb bow?

As draw weight increases, so should arrow rigidity (spine). Also, we strongly recommend that you use an arrow with at least 5 grains of weight per pound or draw weight (if you are shooting a 60 lb. bow, you should use and arrow of not less than 300 grains). This includes your field point or broadhead.

Does arrow length include Nock?

Correct arrow length is measured from the bottom, inside of the nock groove (deepest point where the string goes into the nock) to the cut end of the shaft, not including the point or point insert.

How long should my arrows be for a 29 inch draw?

it depends on the arrows you choose, you need at least 1/4″ of arrow overhang on the rest. so you can probably shoot an arrow that’s about 28 1/4 for rests that are set up normally. and go all the way up to full length 36″ arrows for indoor.